Home Page Forums Raspberry Pi Shields How to use GSM/GPRS shield with Arduino ?

This topic contains 2 replies, has 3 voices, and was last updated by  RochMesa 1 week, 6 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #1934

    hasan.kmbr
    Participant

    Do you have a detailed visual or video on how to connect with shield arduino to use in conjunction with it?

    When connecting to a computer using usb, the usb device is not recognized, I get the error, which drivers do I need to load? (Installed via github with Quectel windows usb drivers installed)

    #34690

    Metin
    Keymaster

    Hi,

    1- You should connect GND/TX/RX/PWR_KEY/VDD_EXT pins to Arduino. To power-up module, PWR_KEY pin should stay HIGH 2 seconds long, then LOW. Then you can send AT commands via Serial.

    2- You should install FTDI FT230X driver. Please check this link > https://www.ftdichip.com/Products/ICs/FT230X.html

    • This reply was modified 3 weeks, 3 days ago by  Metin.
    #34910

    RochMesa
    Participant

    Hi…It’s a piece of software that runs on the Arduino which sends input from the serial monitor to a device connected by SoftwareSerial, and relays any response from that device back to Serial Monitor.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.