Home Page Forums Raspberry Pi Shields Issues using UART of RPI3 with Sixfab 3G module

This topic contains 1 reply, has 2 voices, and was last updated by  Saeed 1 month, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #33228

    Mobashir
    Participant

    Hi,

    Issues using UART of RPI3 with Sixfab 3G module

    I have stacked the shield on top of the RPI3 to use the UART. I can see that the shield gets powered but I’m unable to connect. When I use the USB cable to connect, I’m able to connect using ttyUSB3. I have tried to follow tutorial2 and disabled getty of ttyS0 and ttyAMA0 but no change is observed. Any help on how to connect?

    Best,
    ~mm

    #34649

    Saeed
    Keymaster

    hi,
    Do you have shorted or connected 0 ohm resistor in the UART RESISTORS available below the shield

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.