Home Page Forums Raspberry Pi Shields Need to drive low PERST# on MCPI for hardware reset

This topic contains 0 replies, has 1 voice, and was last updated by  avraham.yoffe 3 months, 1 week ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #38018

    avraham.yoffe
    Participant

    Hi,

    I’m using Sixfab_RPi_3G-4G-LTE_Base_Shield with MCPI-L210.03S module by u-blox
    At some stage communication over USB ttyACM0 was stacked as result of usb reconfiguration (AT+UUSBCONF=13 u-blox)
    I have to issue hardware reset, which could be done by low pin 22 PERST# signal
    Is it possible to be done via shield connected to RPi 3+?

    Thanks in advance!
    Avraham

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.