Home Page Forums Raspberry Pi Shields ppp0 connection

This topic contains 2 replies, has 2 voices, and was last updated by  Luciano 1 week, 2 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #48772

    Luciano
    Participant

    Good morning,
    I’m using the raspberry Pi 3G-4G/LTE Base Shield V2 with a Quectel EC25 Mini PCIe 4G/LTE Module.
    I follow the procedure to activate the PPP0 channel and it goes fine but I can not navigate on internet ( it seems the USB communication line is frozen). The only way the base shield start to work well ( I can navigate on internet) is when I physically disconnect and reconnect the USB connector that connect Raspberry to the Shield ( whitout to power off the power ).
    Please I need a procedure or any suggestion to activate the PPP0 channel and it continues to be active even if i power off and then power on the HW.
    Thanks in advance

    #48837

    ensar
    Participant

    Please share the output of route -n

    #50350

    Luciano
    Participant

    Dear ensar,
    we have solved the problem by adding the following commands. Thanks

    sudo route del default
    sudo route add default ppp0

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.