Home Page Forums Raspberry Pi Shields Raspberry Pi zero W with sixfab Raspberry Pi 3G-4G/LTE Base Shield

This topic contains 1 reply, has 2 voices, and was last updated by  ensar 2 months, 3 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #41521

    Dave Matthews
    Participant

    I am sure it is something that I am doing wrong but I am using a raspberry Pi zero W along with the EC25_e GSM module and the sixfab Raspberry Pi 3G-4G/LTE Base Shield V2.
    GPIO4 is triggered by a PIR module and a photograph is taken and then emailed over the GSM system. If I use the mini PCIe_Evalb V1.05 everything works exactly as expected. The problem comes when I plug the sixfab board in and no GSM connection is made. Please note the camera doesn’t operate unless a GSM signal is logged on.
    I know the SIM card works along with the camera, antenna PIR and the Pi.
    Any suggestions are gratefully accepted if it stops me going bald by pulling my hair out

    #48525

    ensar
    Moderator

    Hi.

    Were you connected via USB?

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.